+- How2pass.com Forums (https://www.how2pass.com/forum)
+-- Forum: CCNP (https://www.how2pass.com/forum/forum-6.html)
+--- Forum: CCNP ENARSI 300-410 Forum (https://www.how2pass.com/forum/forum-15.html)
+--- Thread: QIDRTE572 (/thread-1709.html)
QIDRTE572 - BManager - 01-01-2020
QIDRTE572
should be Router Subcommand i think?
to enable rip you type in the global config:
Router rip
the question says on a link so that is already in the router mode to enable on a link you type the network command
network 10.10.10.1
R3(config)#
R3(config)#router rip
R3(config-router)#network 10.1.1.5
RE: QIDRTE572 - ugly9727 - 01-02-2020
I agree. If it says on a interface, it should be in the router sub command by including network statement. If its just enabling routing protocol then its global.