How2pass.com Forums
Cisco 350-401 Exam Experience - Printable Version

+- How2pass.com Forums (https://www.how2pass.com/forum)
+-- Forum: CCNP (https://www.how2pass.com/forum/forum-6.html)
+--- Forum: CCNP ENCOR 350-401 Forum (https://www.how2pass.com/forum/forum-19.html)
+--- Thread: Cisco 350-401 Exam Experience (/thread-2497.html)



Cisco 350-401 Exam Experience - networman - 07-05-2025

Thanks to how2pass for the study material. I received a Pass today on the exam. For those interested - you start off with 6 labs. All of the labs on this site are spot on. Be extremely careful with what devices you are configuring. I actually configured the wrong CoPP Router today. By the time I realized it, it was too late. It appears after a certain amount of time the system locks the devices down. 

Then onto 60 questions with drag and drop and multiple choice. Gonna say 95% was from 1.1 and the rest from 1.0. I didn't do as well as I would of liked too, but still received the Pass. 

Good luck to all.


RE: Cisco 350-401 Exam Experience - sgtwardo - 07-05-2025

(Yesterday, 07:04 PM)networman Wrote: Thanks to how2pass for the study material. I received a Pass today on the exam. For those interested - you start off with 6 labs. All of the labs on this site are spot on. Be extremely careful with what devices you are configuring. I actually configured the wrong CoPP Router today. By the time I realized it, it was too late. It appears after a certain amount of time the system locks the devices down. 

Then onto 60 questions with drag and drop and multiple choice. Gonna say 95% was from 1.1 and the rest from 1.0. I didn't do as well as I would of liked too, but still received the Pass. 

Good luck to all.

Congrats. Did you notice any particulars with the sims? 

I know I skipped the CoPP last time cause it appeared to me that the entire thing needed to be built from scratch.


RE: Cisco 350-401 Exam Experience - networman - 07-05-2025

All Labs were very similar to whats here on how2pass. The CoPP lab needed to be configured on R30 instead of R10. I did exactly what I did here and verified with the sh policy-map control plane. It checked on for me.

Hope that helps.