+- How2pass.com Forums (https://www.how2pass.com/forum)
+-- Forum: CCNP (https://www.how2pass.com/forum/forum-6.html)
+--- Forum: General Discussion (https://www.how2pass.com/forum/forum-14.html)
+--- Thread: CCNA / CCNP Home Lab (/thread-752.html)
CCNA / CCNP Home Lab - sumncguy - 01-25-2013
I am trying to setup my home lab.
Its consists of 3 2610s, 2 2950s and 1 3550.
I want to use the 3550 as a layer 2 switch only (at this point).
Im having problems getting it to connect to the 2610.
I see the vlan 1 and fa0/1 (in switchport mode) up. But CDP isnt working.
Can someone point me in the right direction ? Output is given below ...
3550_1#show ip int br
Interface IP-Address OK? Method Status Protocol
Vlan1 192.168.10.3 YES manual up up
FastEthernet0/1 unassigned YES unset up up
FastEthernet0/2 unassigned YES unset down down
FastEthernet0/3 unassigned YES unset down down
FastEthernet0/4 unassigned YES unset down down
3550_1#show cdp nei det
3550_1#
Re: CCNA / CCNP Home Lab - ademirch - 02-17-2013
Can you pls send configurations for both ports?
Re: CCNA / CCNP Home Lab - john3721 - 09-16-2013
did you try cmd CDP RUN ?