05-05-2010, 08:12 PM
Hello,
I think this one is a trick question perhaps in regards to the solution 'VLAN 1' (the other one makes sence, of course):
"24. (QID:BCM363) The lack of which two prevents VTP information from propagating between switches? (Choose two)"
.... meaning:
vtp1(config-if)#switchport trunk pruning vlan 1
Command rejected: Bad VLAN pruning list.
vtp1(config-if)#
.... in other words, it can't be done (vlan 1 cannot be prunned; ergo - its not possible to 'lack it' in that regard anyway). If I start blank, remove 1 from the allowed list (sw trunk all vlan...) on either end and set VTP up one side the other picks it up.
hears the full question pasted from Opera:
24. (QID:BCM363) The lack of which two prevents VTP information from propagating between switches? (Choose two)
a trunk port
VLAN 1
a root VTP server
VTP priority
I think this one is a trick question perhaps in regards to the solution 'VLAN 1' (the other one makes sence, of course):
"24. (QID:BCM363) The lack of which two prevents VTP information from propagating between switches? (Choose two)"
.... meaning:
vtp1(config-if)#switchport trunk pruning vlan 1
Command rejected: Bad VLAN pruning list.
vtp1(config-if)#
.... in other words, it can't be done (vlan 1 cannot be prunned; ergo - its not possible to 'lack it' in that regard anyway). If I start blank, remove 1 from the allowed list (sw trunk all vlan...) on either end and set VTP up one side the other picks it up.
hears the full question pasted from Opera:
24. (QID:BCM363) The lack of which two prevents VTP information from propagating between switches? (Choose two)
a trunk port
VLAN 1
a root VTP server
VTP priority