Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Lab #6 Question
#1
In Lab #6 it has you setup up port aggregation along with trunking between two switches.  See below:

SwitchA(config)#int range fa0/3 - 4
SwitchA(config-if-range)#no switchport access vlan 98
SwitchA(config-if-range)#switchport mode trunk
SwitchA(config-if-range)#switchport trunk allowed vlan 1,21-23
SwitchA(config-if-range)#switchport trunk native vlan 99

SwitchA(config-if-range)#channel-protocol lacp
SwitchA(config-if-range)#channel-group 1 mode active
SwitchA(config-if-range)#exit

SwitchA(config)#int port-channel 1
SwitchA(config-if)#switchport trunk native vlan 99


My question is why in this lab do you configure trunking on the seperate interfaces before creating the etherchannel?  I would expect to create the etherchannel and then apply the trunking commands to the port-channel.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)