Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Unless I'm missing something I don't think the answer listed as correct is actually valid in this question.

What does the command vlan dot1q tag native accomplish when configured under global configuration?

*Control Traffic is tagged

*All Frames within the native VLAN are tagged, except when the native VLAN is set to 1

*It removes the 4-byte dot1q tag from every frame that traverses the trunk interface(s)

*It allows control traffic to pass using the non-default VLAN

Correct answer is listed as control traffic is tagged but this is not correct according to cisco.

"Control traffic continues to be accepted as untagged on the native vlan on a trunked port, even when the vlan dot1q tag native command is enabled"

Messages In This Thread
QID SW447 - by upirons - 09-05-2019, 11:46 AM

Forum Jump:

Users browsing this thread: 1 Guest(s)