Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
trouble with NAT and PAT
#1
Hi am am trying to do the ccna skills 4 test, which includes:

frame relay
ppp
eigrp
dhcp
nat
pat
configure static routes.

Everything works fine until I get to NAT and PAT.

Here is the outline:
3 routers = ISP, Sydney, Auckland
ISP>Sydney  = Frame relay
Sydney> Auckland  = ppp with chap

regarding NAT the tasks are:
NAT to translate the 10.0  addresses to a 192.168.100.0/24. Use PAT to ensure that only the addresses 192.168.100.11 to .20 are translated to.
Use a static mapping of 10.10.0.1 to 192.168.0.1


my nat configs on ISP are

Interface e 0 = 10.10.0.1/16
ip nat inside
int s 0/0 = 192.168.2.1 /30
ip nat outside


access-list 1 permit 10.10.0.0 0.0.255.255
ip nat pool NAT 192.168.100.11 192.168.100.20 netmask 255.255.255.0
ip nat inside source static 10.10.0.1 192.168.100.1
ip nat inside source list 1 pool NAT overload

Sydney has a default route pointing back to ISP, which has also been redistributed to Auckkland.

Any ideas why the NAT dont work.
I cant see why

Thanks
Reply


Messages In This Thread
trouble with NAT and PAT - by ny167 - 04-23-2008, 10:58 PM
Re: trouble with NAT and PAT - by directly_connected - 04-30-2008, 01:12 AM
Re: trouble with NAT and PAT - by directly_connected - 04-30-2008, 01:14 AM
Re: trouble with NAT and PAT - by fraggle0701 - 07-05-2009, 04:25 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)