Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
QID:BCM128 Missing info in the question
refer to question QID:BCM128: VLAN 1 and VLAN 2 are configured between the switches SW1 and SW2 in the exhibit. What should be done to load balance VLAN traffic between SW1 and SW2?

The question is misleading since there is no information where the root bridge is!
The answer Lower the port priority for VLAN 1 on port 0/2 for Switch SW1 is only correct in the case the root switch is SW1. The other way around (SW2 is the root) no answer matches.

Any other comments?
They must have left out the priorities/MAC addresses of the switch by mistake.  I'll e-mail them about it.
I just seen this too!!!

Forum Jump:

Users browsing this thread: 2 Guest(s)