Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SW678
#1
Where is it exactly in this exhibit that it shows that "PC1 and PC3 use the router R1 as their primary gateway"? I just dont see it. 

I thought: I thought because it "requires appropriate distribution of Virtual GW IP per Clients for optimal load-balancing (generally through DHCP)", that I wouldn't be able to discern  who their primary was because the DHCP config is not shown. 

So what am I missing?

Rl(config)# interface gigabitethernet 1/0/1

R1(config-if)# ip address 10.1.0.2 255.255.255.0
R1 (config-if)# vrrp 1 priority 150
R1(config-if)# vrrp 1 ip 10.1.0.1
R1(config-if)# vrrp 2 priority 120
R1 (config-if)# vrrp 2 ip 10.1.0.10
R1(config-if)# no shutdown

R2(config)# interface gigabitethernet 1/0/1
R2(config-if)# ip address 10.1.0.3 255.255.255.0
R2 (config-if)# vrrp 1 priority 120
R2(config-if)# vrrp 1 ip 10.1.0.1
R2(config-if)# vrrp 2 priority 150
R2 (config-if)# vrrp 2 ip 10.1.0.10
R2(config-if)# no shutdown
Reply
#2
If you look at the priorities for vrrp 1, you will see that R1 is 150 and R2 is 120, therefore R1 is the Master for Group1. You will also see that 10.1.0.1 is the virtual IP for vrrp 1 Then look

at the exhibit. You will see that both PC1 and PC3 have a default gateway of 10.1.0.1.
Reply
#3
(02-11-2020, 12:14 PM)dansally Wrote: If you look at the priorities for vrrp 1, you will see that R1 is 150 and R2 is 120, therefore R1 is the Master for Group1.  You will also see that 10.1.0.1 is the virtual IP for vrrp 1 Then look

at the exhibit.  You will see that both PC1 and PC3 have a default gateway of 10.1.0.1.

Thank you.  I didn't see the exhibit button down there.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)