07-16-2009, 06:43 PM
Hi All,
I have been reviewing Lab #5 2nd part, where DSW1 is configured with a Vlan access-map.
In the configuration traffic is being matched against ip address 1 such as
"DSW1(config-access-map)# match ip address 1"
I presume ip address 1 would be an access list defining IP range that needs to be allowed or blocked depending on the question. But I do not see anything mentioned about definig the access list on the Lab, or I can not see any list defined in the show run output for DSW1 switch.
Any ideas why there is no access list defined? I guess defining an access list for matching the vlan map criteria is required.
Regards
I have been reviewing Lab #5 2nd part, where DSW1 is configured with a Vlan access-map.
In the configuration traffic is being matched against ip address 1 such as
"DSW1(config-access-map)# match ip address 1"
I presume ip address 1 would be an access list defining IP range that needs to be allowed or blocked depending on the question. But I do not see anything mentioned about definig the access list on the Lab, or I can not see any list defined in the show run output for DSW1 switch.
Any ideas why there is no access list defined? I guess defining an access list for matching the vlan map criteria is required.
Regards