Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Question about Lab #5
Hi All,

I have been reviewing Lab #5 2nd part, where DSW1 is configured with a Vlan access-map.
In the configuration traffic is being matched against ip address 1 such as

"DSW1(config-access-map)# match ip address 1"

I presume ip address 1 would be an access list defining IP range that needs to be allowed or blocked depending on the question. But I do not see anything mentioned about definig the access list on the Lab, or I can not see any list defined in the show run output for DSW1 switch.

Any ideas why there is no access list defined? I guess defining an access list for matching the vlan map criteria is required.

H2P Hands on lab # 5 is simply a blunder.

Forum Jump:

Users browsing this thread: 1 Guest(s)