Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
QID:BCM428
#1
If the HSRP standby device is on default configuration then don't the following apply also...

Answer 1 - By default HSRP does not have preempt enabled, so if the standby was active and then SW1 came back with a higher priority, it won't assume the active role because of this?

Answer 3 - Preempt is enabled so if the standby has a higher priority, it would assume the active role!?

Anyone?
Reply
#2
Please check your QID#, 428 reflects wireless client association steps. Not HSRP.
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)