07-27-2025, 07:18 PM
Hi forum support / admin
According to QID:AR143 explanation end paragraph:
"Manually configuring an ipv6 address on router 2 will it an address on the same subnet as router 1. This will allow router 2 to successfully telnet." Yet the answer correct answer is "permit ip any any on access-lit egress." I would add pictures if i could. Nonetheless, please fix.
Thanks,
GreaterZen
According to QID:AR143 explanation end paragraph:
"Manually configuring an ipv6 address on router 2 will it an address on the same subnet as router 1. This will allow router 2 to successfully telnet." Yet the answer correct answer is "permit ip any any on access-lit egress." I would add pictures if i could. Nonetheless, please fix.
Thanks,
GreaterZen