10 hours ago
(Today, 09:40 AM)help_desk Wrote: Congratulations!
In the DMVPN OSPF simulation, the task stating that the spokes must communicate with each other indicates that you need to configure DMVPN Phase 2. In Phase 2, the spokes communicate directly with each other instead of sending all traffic through the hub.
Congratulations again, and best of luck with your future endeavors! If you have a moment, we'd also greatly appreciate it if you could share your experience on our testimonials page.
https://www.how2pass.com/comments-testimonials.php
If i remember the preconfigured cli on the parts; the main thing missing would be to change the already set up 'ip nhrp map multi <HUB PHYSICAL INTERFACE>' over to dynamic on the spokes. This should have popped them into directly communicating.