Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
QID AN034
#1
I believe that the current answer of 'passive' is incorrect. It is the neighbor S2 that is passive. And that question asks:

"Refer to the Exhibit. Based on the LACP neighbor status, in which mode is the SW1 port-channel configured?"

I believe the answer would be 'active.'

I went out and checked many free testing sites and they said the same. So this is confusing.
Reply
#2
Ok, the answer and explanation have been fixed.
Reply
#3
(02-15-2021, 03:57 AM)forumsupport Wrote: Ok, the answer and explanation have been fixed.
Thank you, it was quite confusing.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)