Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
bad question- answer
#1
RTE 753 question doesn't have the correct answer.


OSPF uses router id than highest ip on a  loopback interface and than normal IPV4 interface that is in the UP condition.
So if you configure a new LB ip address and reboot the router. it still uses the original ROUTER ID that was assigned.
Reply
#2
You are right. The answer and explanation have been updated.
Reply
#3
Thanks
Reply
#4
Hi all,

Where can i find questions pool and study materials located on how2pass page ?

Thanks in advice.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)