Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
CCNA / CCNP Home Lab
#1
I am trying to setup my home lab.

Its consists of 3 2610s, 2 2950s and 1 3550.

I want to use the 3550 as a layer 2 switch only (at this point).

Im having problems getting it to connect to the 2610.

I see the vlan 1 and fa0/1 (in switchport mode) up. But CDP isnt working.

Can someone point me in the right direction ? Output is given below ...

3550_1#show ip int br
Interface                  IP-Address      OK? Method Status                Protocol
Vlan1                      192.168.10.3    YES manual up                    up
FastEthernet0/1            unassigned      YES unset  up                    up
FastEthernet0/2            unassigned      YES unset  down                  down
FastEthernet0/3            unassigned      YES unset  down                  down
FastEthernet0/4            unassigned      YES unset  down                  down

3550_1#show cdp nei det
3550_1#
Reply
#2
Can you pls send configurations for both ports?
Reply
#3
did you try cmd CDP RUN ?
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)